Dispensing Robot

Product Details:

The Loctite® 300D Series Benchtop Robot has a 300 mm by 320 mm range of operation. Eight different configurations, as shown in the chart, are available to meet your process requirements. This unit is fully compliant with Robotics Industry Association (RIA) safety guidelines. Programming accessories, dispensing equipment, integration cables and mounting hardware are sold separately.

Features:

• Designed for adhesive dispensing.
• Independent dispense On/Off purge control button on front panel allows adhesive to be purged from a dispense valve to prevent curing or for aiding initial setup. Great for purging of two-part materials that have a very short pot life. No special programming required.
• Integrated solution – plug and play accessories.
• Software utility program compensates for positional offsets when dispense needle tips or barrels are changed.
• Teach Pendant program storage capabilities allows dispense program to be easily transferred from robot to robot.
• Over-speed error indicator prevents robot from traveling too fast during the execution of the program.
• 100 programs, 4,000 points memory per program, compact flash card.
• Brush area function command allows the tip to “paint” a specifically designed area.
• Shortcut keys for common tasks.
•  No programming experience required

integration Accessories

• Teach Pendant – 1328356Your Loctite® 300D series includes one dispensing cable so you can hook up to any one of our following dispensing systems:
• Loctite® Solenoid Valve Module 24 V – 988000.• Loctite® Integrated Semiautomatic Dispensers – 1390321, 1390322.• Precision Syringe Dispenser – 97006.• Digital Syringe Dispenser – 883976 (Adapter cable, 1053227, also required).
• Loctite® Posi-Link™ Volumetric Syringe and Dual Cartridge Systems.
• Loctite® DuraPump™ Systems.For additional integration, including low level signal operation, use:
• Loctite® D Series Interface Cable – 1329222– 25-pin male “D shell” electrical connector that connects into rear of robot. – 3-pin female round connector that connects into robot.9-pin male “D shell” electrical connector that connects into Dispensing Unit or Solenoid Valve Module.
• Loctite® 24 Volt Interface Junction Box – 1461974.
• Loctite® Solenoid Valve Module for pneumatic control by the robot – 988000.

Product Details:

Features:
•Designed for adhesive dispensing.
•Independent dispense on/off purge control button on front panel allows adhesive to be purged from a dispense valve to prevent curing or for aiding initial set-up. Great for purging two-part materials that have a very short pot life.
•No special programming required.
•Integrated solution - plug and play accessories.
•Software utility program compensates for positional offsets when dispense needle tips or barrels are changed.
•Teach Pendant program storage capabilities allows dispense program to be easily transferred from Robot to Robot.
•Over-speed error indicator prevents Robot from traveling too fast during the execution of the program.
•100 programs, 4,000 points memory per program compact flash card.
•Brush area function command allows the tip to "paint" a specifically designed area.
•Shortcut keys for common tasks.
•No programming experience required.


The Teach Pendant, dispensing equipment, cables and mounting hardware must be purchased separately